Accessing The User Menu; Omitting Zones - Scantronic i-on Serie Benutzerhandbuch

Accessing the User menu

The User menu gives access to user
options such as to omit zones, view log
information and add new users. The range
of options available to you depends on
your user type (privileges).
To access the User menu:
1. Make sure the display shows the
standby screen.
2. Press .
3. Enter your user code:
Enter Access Code:
(*
The first option is displayed:
MENU
Omit Zones
Press  or  to scroll through the
options, followed by  to select the
option you require. The options are
fully documented in the Administration
and User Manual .
4. To leave the menu and return to the
standby screen, press  (if necessary,
several times).

Omitting zones

You can omit a zone before setting the
system. Omitting a zone prevents it from
generating an alarm if the zone is triggered
while the system is set. You may, for
example, want to omit a zone that protects
a garage to enable access without causing
an alarm while the system is set.
Note: The zone returns to normal operation
when the system is unset.
Note: You can omit only those zones that
the installer has specified can be omitted.
To omit zones:
1. Access the User menu, as described in
the previous section.
Page 10
)
>
2. Select the Omit Zones option. The first
zone you can omit is displayed. For
example:
OMIT ZONES
Zone 000
An "O" is displayed at the end of the
line if the zone is Omitted. An "I" is
displayed if the zone is Included.
3. Press  or  to display the zone you
wish to omit, then  to mark it for
omission. Press  again if you made
a mistake and want the zone to be
included.
Repeat this step for any other zones
you wish to omit (or change to be
included).
4. Press  to store changes.
This product must be installed and
maintained only by qualified service
personnel.
The information, recommendations, descriptions and safety
notations in this document are based on Eaton Corporation's
("Eaton") experience and judgment and may not cover all
contingencies. If further information is required, an Eaton sales office
should be consulted. Sale of the product shown in this literature is
subject to the terms and conditions outlined in appropriate Eaton
selling policies or other contractual agreement between Eaton and
the purchaser.
THERE ARE NO UNDERSTANDINGS, AGREEMENTS, WARRANTIES,
EXPRESSED OR IMPLIED, INCLUDING WARRANTIES OF FITNESS
FOR A PARTICULAR PURPOSE OR MERCHANTABILITY, OTHER
THAN THOSE SPECIFICALLY SET OUT IN ANY EXISTING CONTRACT
BETWEEN THE PARTIES. ANY SUCH CONTRACT STATES THE ENTIRE
OBLIGATION OF EATON. THE CONTENTS OF THIS DOCUMENT
SHALL NOT BECOME PART OF OR MODIFY ANY CONTRACT
BETWEEN THE PARTIES.
In no event will Eaton be responsible to the purchaser or user in
contract, in tort (including negligence), strict liability or other-wise
for any special, indirect, incidental or consequential damage or loss
whatsoever, including but not limited to damage or loss of use of
equipment, plant or power system, cost of capital, loss of power,
additional expenses in the use of existing power facilities, or claims
against the purchaser or user by its customers resulting from the use
of the information, recommendations and descriptions contained
herein. The information contained in this manual is subject to change
without notice.
© 2019 Eaton.
Eaton, Security House, Vantage Point Business Village,
Mitcheldean, GL17 0SZ. www.touchpoint-online.com
SecureConnect is a trademark of Eaton.
I