Waste Electrical And Electronic Equipment (Weee) - Avermedia Capture Box C281 Bedienungsanleitung

European Community Compliance Statement
Class B
This product is herewith confirmed to comply with the requirements set out in the Council Directives on the
approximation of the laws of the Member States relating to Electromagnetic Compatibility Directive (EMC) 2004 /
108 / EC, Low Voltage Directive (LVD) 2006/95/EC and Energy-related Products Directive (ErP)
2009 / 125 / EC.

WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE)

The mark of Crossed-out wheeled bin indicates that this product must not be disposed of with your other
household waste. Instead, you need to dispose of the waste equipment by handing it over to a designated
collection point for the recycling of waste electrical and electronic equipment. For more information about where
to drop off your waste equipment for recycling, please contact your household waste disposal service or the shop
where you purchased the product.
FCC Compliance Statement (United States)
FCC Class B Part 15
This device complies with Part 15 of the Federal Communications Commission (FCC) Rules. The FCC ID for this device is
L6ARCR10BW. Operation is subject to the following two conditions:
This device may not cause harmful interference.

 This device must accept any interference received, including interference that may cause undesired operation.
CAUTION:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
manufacturer's instructions, may cause interference harmful to radio communications.
There is no guarantee, however, that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio or TV technician for help.

iii