Inhaltsverzeichnis
Werbung
Chapter 3
3.1 Hardware Installation
Please follow the steps below to properly connect the Capture Box and your TV / video game consoles.
The Capture Box supports one game console connection at a time only. Connecting more than one console
to the Capture Box at the same time may result in video quality issues, even if only one console is on.
Before making the connections, make sure to set game console's video output to "Component" and adjust its
output resolution to 1080p or below. Then power your game console off.
If you would like to install internal hard drive, install it before making the connections.
Make sure that the cables are firmly connected and that neither of the cables are loose. If any of the cables
are loose or disconnected, there may be a loss of signal or screen color problems.
Step 1
Connecting the Device to Your Game Console Using Universal Component
Cable
Universal Component Cable is used to hook up your game console to the Capture Box at a time.
This cable is composed of component video cable with RCA audio cable at one end and three cables
compatible with PS2/3, Xbox and Wii at the other end.
Step 1-1
:
Plug the green, blue, red connectors into the COMPONENT VIDEO IN port on the rear of the device.
Step 1-2
:
Plug the white and red connectors into the AUDIO IN port on the rear of the device.
Step 1-3
:
Plug the other end to your game console (choose a console-specific cable).
Make sure not to mix up the two red cables.
Installation & First Time Setup
English-7
Werbung
Inhaltsverzeichnis
