Axis T93F-Serie Installationsanleitung Seite 21

4
Example image: AXIS T93F20 and AXIS P13 Series
1
Holder screw T20 (2x)
2
Holder
3
Position A (overlap) : +3.7 mm (+0.15 in)
4
Position B (gap) : -6 mm to -4 mm (-0.24 in to -0.16 in)
NO TICE NO NO TICE TICE
• Position A: To avoid reflections in the image, adjust the holder's position so that the
camera lens edge overlaps the bottom cover edge by +3.7 mm (+0.15 in). Note that
this position voids the IK10 rating.
• Position B: To fullfill the IK10 rating requirements, adjust the holder's position so
that the gap between the camera lens and bottom cover edges is between -6 mm and
-4 mm (-0.24 in and -0.16 in).
5. (AXIS T93F10, AXIS T93F20) Connect the heater cable to the heater connector in the
bottom cover.
6. If using an SD card for local storage, insert the card into the camera's SD card slot.
7. Connect the network cables.
- (AXIS T93F05, AXIS T93F10) Connect the camera to the network.
AXIS T93F Series
21
2
3