Install The Hardware - Axis T93F-Serie Installationsanleitung

Cable Area
NO TICE TICE
NO NO TICE
• Use cables that keep within the specified cable area.
• Select cables in compliance with your local regulations.
• Make sure all cable holes are properly sealed.
Diameter
5–15 mm (0.197–0.591 in)
To create extra cable holes, open the drill-outs located below the holder. See Hardware Overview
on page 9.
NO TICE TICE
NO NO TICE
Use cable gaskets or cable glands that match both the cable hole and the cable area.
For information about accessories, such as cable gaskets and cable glands that allow for other
cable areas, see www.axis.com

Install the Hardware

NO TICE TICE
NO NO TICE
• Due to local regulations or the environmental and electrical conditions in which the
product is to be used, a shielded network cable (STP) may be appropriate or required.
All cables connecting the product to the network and that are routed outdoors or in
demanding electrical environments shall be intended for their specific use. Make sure that
the network devices are installed in accordance with the manufacturer's instructions.
(AXIS T93F05) For information about regulatory requirements, see the camera's
Installation Guide.
(AXIS T93F10, AXIS T93F20) For information about regulatory requirements, see
Regulatory Information on page 2
• Be careful not to scratch, damage or leave fingerprints on the window because this could
decrease image quality.
The Axis product can be installed with the cables routed through or along the wall.
Read all the instructions before installing the product:
1. Install the wall mount. See page 16. For detailed instructions, see the wall mount's
Installation Guide, supplied in the package or available on www.axis.com
AXIS T93F Series
AWG
Approximately 4–6/0
15