After Use; Storing The Headphones - Pioneer SE-NC70S Bedienungsanleitung

Noise canceller + SRS surround
function
1 Set the headphones' power switch to
ON2.
The green power indicator will light, and both
the noise canceller and SRS surround
functions will operate.
*1 The SRS surround function utilizes SRS HEADPHONE
technology developed by SRS Labs, Inc., (USA) to
reproduce headphone sound with a greater sense of
three-dimensional realism. When using headphones
equipped with SRS HEADPHONE technology, music is
not focused on the center of the head, but is
reproduced with a greater sense of natural expanse.
Note
• The noise-canceller function is designed to
reduce noise primarily in the low-frequency
range, and is not effective at reducing high-
frequency noise.
• If the headphones' microphone is covered
with your hand or other object, feedback
may be caused, resulting in a "howling"
sound. In this case, remove your hand or
other obstruction from the microphone.
6
En
*1 • The effectiveness of the noise canceller

After use

1
Sound can still be heard from the headphones
when the power switch is set to OFF, but the
noise-canceller function will not operate to
lower environmental noise.

Storing the headphones

When not in use, store the headphones as
shown below.
1
2
3
with the ear pads.
Microphone
function may vary depending on the way in
which the headphones are worn.
Set the power switch to OFF.
Reverse the direction of the ear pads.
Fold the headband as shown.
Fold the headband as shown to align