Automatic Mode - Bpt KX4MA6A Handbuch

GENERAL DESCRIPTION
PERFORMING PRIORITY CONTROLS
When an override activation command is received, the actuator brings the load to the
position defined by the priority command (UP or DOWN). The actuator ignores any other
commands received (including weather alarm and lock) until the priority command is
withdrawn.
The behaviour of the actuator upon withdrawal of the priority command can be defined
during the programming phase.
LOCK EXECUTION
It is possible to lock the device-connected load in a specific position (that can be set)
when the lock activation command is received; any other command received (apart from
the override activation command) will be ignored until this function is deactivated.
SCENE MANAGEMENT
The actuator can manage up to 8 scenes, each of which reproduces a specific position
for the connected load.
It is possible to store a particular position by means of the relative scene learning
command; the learning function can be enabled/disabled via the KNX command.

AUTOMATIC MODE

The device can carry out autonomous movements to take advantage of sunlight, for
instance to warm the room; you can define the position to which the load must move in
order either to protect the room against direct sunlight (therefore keeping it cool), or to
exploit the sun to warm the room.
Using the automatic mode selection commands, you can activate/deactivate one of the
above-mentioned functions.
18