gc D Light Pro Betriebsanleitung Seite 11

►
HOW TO PERFORM A PATCH TEST
Because the skin tone varies from area to another, you should perform a patch test to each body area to be treated. First
check your skin tone comparing it with the skin color chart on the instruction manual and packaging.
Identify a small area to be treated.
Shave the area to be treated.
After having set to the lowest level, apply the handpiece to the area and emit the first pulse. If you do not feel any kind of
discomfort, increase the energy to the next level, move the handpiece to the adjacent part of skin and emit a new flash.
Increase the energy level on every part of the next skin until reaching the highest level (but it must remain bearable depending
on skin type). During treatment it is possible (and normal) to feel a warm sensation on the skin. If there is a feeling of
discomfort, it means that the highest energy level endured the previous one.
After 24 hours check the area: the persistence of redness indicates that the skin tolerated the highest energy level on the
previous one. Although it is extremely rare, if hypersensitivity persists for more than 24 hours, it is advisable to consult
a physician.
CAUTION: The energy directly delivered affects the result, but because of the principle
treatment, you should not exceed the maximum threshold that your skin is able to tolerate. This threshold is normally high for
light skins and low for dark skins, because the presence of melanin darkens the skin, increases heat production.
Do not exceed the highest threshold that your skin can tolerate without any kind of discomfort.
16
MAINTANANCE
CLEANING AND CONSERVATION
It is recommended to clean the Flash window after each epilation session:
Switch off the appliance by holding the ignition button down (9) and disconnect the Power plug (6)
Gently wipe the flash window of the device (11) with a clean dry cloth. For proper cleaning of the flash area, it is highly
recommended to use Kera Flux detergent at luce-pulsata.net
Store the appliance in a cool dry place, away from heat and water sources
When the light is empty, the counter reaches zero.
NOTE:
If large stains appear inside the treatment surface (11) or if the latter is cracked or broken, do not use the appliance and
contact the D Light Service center. After replacing the lamp, always set the energy level to lower than the one used normally.
In the next session, increase the energy level again only if the there is no abnormal discomfort during or after treatment.
Never immerse the appliance or any of its parts in water!
17