Herunterladen Inhalt Inhalt Diese Seite drucken

Inspection Before Use - gc D Light Pro Betriebsanleitung

Ed-polymerisationslampe
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 14
Minimal Skin Discomfort
Despite the domestic pulsed light treatments are generally tolerated very well, most users try a annoyance during use,
generally described as a slight warm sensation or a pinch on the treated skin areas. This sensation can be an alert during
application or for a few minutes after application. Any sensation beyond this minimal annoyance is not normal and it means
that you need to interrupt the use because your skin is not able to tolerate epilation treatment, or the energy level is too high.
Skin Redness
Skin may be reddened immediately after using appliance or during the following 24 hours. Redness generally disappears
within 24 hours. Consult your physician if the redness does not disappear within 2 or 3 days.
Increased Skin Sensitivity
The skin of the treated area becomes more sensitive and can be dry or scaly.
Skin wounds and burns
Burns or wounds may occur after application. They may take a few weeks to heal, and, in very rare cases, may leave a
visible permanent scar.
Scars
Although it is very rare, permanent scars may be formed. Generally when scars are formed, they have a flat lesion and white
skin (hypertrophic). However, the scar may be very large and red (hypertrophic) or large and extends beyond the margins of
the wound itself (keloid). Subsequent aesthetic treatments can be necessary to improve the appearance of the scar.
Pigmentation Changes
In some rare cases there is a risk of temporary pigmentation (greater pigment or
Brown bleaching) or IPO-pigmentation (whitening) on the surrounding skin area leeping. The risk of skin pigmentation change
is higher for people with dark skin complexion
Redness and excessive swelling
In some rare cases the skin can become very red and swollen. This is more common in sensitive areas of the body. Redness
and swelling should decrease between 2 and 7 days later, it must be cured with frequent applications of ice. You can gently
wipe the area, but avoid exposing to the sun.
Infection
Infection of the skin is very rare but it is a possible risk due to scalding or injury caused by the device.
Bruises
Very seldom use of the device may cause blue-violet bruises that may last from 5 to
10 days.
14
EPILATION TREATMENT AREA
The appliance can be used to remove unwanted hair from the body on the following areas: Armpits, bikini line, arms, legs,
back, chest. It can also be used on the feminine face
In the area under the cheekbones and without getting too close to the eyes and wearing the protective goggles provided. It is
important to only treat areas of the face where superfluous hair is present visible, thick and dark. Thin blond hair on the chin
area should not be treated and the area under the chin.
PHOTOREJUVENATION TREATMENT AREA
The appliance can be used to remove unwanted hair from the body on the following areas: Armpits, bikini line, arms, legs,
back, chest. It can also be used on the feminine face
In the area under the cheekbones and without getting too close to the eyes and wearing the protective goggles provided. It is
important to only treat areas of the face where superfluous hair is present visible, thick and dark. Thin blond hair on the chin
area should not be treated and the area under the chin.
NOTE:
Treating the same body part more frequently than recommended does not improve results. Due to hormonal and
physiological changes or other type, hair follicles, latents can become active. Hair removal sessions or occasional
maintenance treatment can therefore be necessary.
Individual reaction depends on hair type and biological factors that can affect the hair growth cycle. Compared to the
recommended epilation program, some people may react faster or slower.
The appliance is not effective on very clear hair, on naturally white, gray, light blond and red hair (see color scale on the
packaging). If the hairs of your body are one of these colors, the device will not be effective.

INSPECTION BEFORE USE

ENERGY LEVEL
The appliance can be set to 10 energy levels, from 1 (the lowest) to 10 (the highest),
Represented by 10 energy level indicator lights (13).
As the enegry level increases, so does the results, as well as the risk of possible side effects. It is advisable to perform a test
patch to identify the right energy level according to proper tolerance.
15

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für gc D Light Pro

Inhaltsverzeichnis