Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
Specification
4.3 Securing the system rails
f Place the system rails on the angular brackets. Ensure that
f
the open sides of the system rails point upwards.
f Insert the bolts with washers through the first, third and
f
fourth holes of the angular brackets.
f Secure the bolts with the retaining clips and nuts.
f
f Tighten the nuts securely with a spanner.
f
4.4 Securing the external unit
Note
Lifting straps to transport the appliance can be hooked
into the area highlighted in grey at the bottom of the
support frame.
f Undo the appliance feet from the external unit. Dispose of
f
the appliance feet.
f Screw the rubber buffers into the illustrated positions on
f
the external unit.
WK 2
Material losses
!
Ensure that the external unit does not slip from the
wall mounting bracket during installation.
f Place the retaining clips on the system rails.
f
f Position the external unit with the rubber buffers on the
f
retaining clips on the system rails.
f Insert the front bolts with washers and slide nuts into the
f
system rails from the front.
f Ensure that the slide nuts are aligned at right angles to the
f
system rails.
f Insert the bolts through the retaining clips into the front
f
rubber buffers and tighten lightly.
f Insert the rear bolts with washers through the retaining
f
clips into the rubber buffers.
f Tighten all the bolts securely with a spanner.
f
f Attach the end caps to the ends of the system rails.
f
Material losses
!
Have a qualified contractor check the installation to
ensure that the appliance is permanently and securely
installed.
5. Specification
5.1
Data table
Support length
Weight
Suitable for
WK 2
234722
mm
950
kg
175
15/20/25 AC(S)
| 7
Werbung
Inhaltsverzeichnis
