Herunterladen Inhalt Inhalt Diese Seite drucken

Connect 28 WG Installation, Gebrauch Und Wartung Seite 25

Inhaltsverzeichnis

Werbung

GB
5.3
HOW TO REPLACE THE UV LAMP
The lamp must be replaced every 6000 hours of working
(about 8 months)
This operation should be performed by a qualified technician.ato
• Wear protection latex disposable gloves to avoid touching the lamp with
your hands. The contact with the skin can prejudice the duration of the
lamp
How to replace the lamp:
• disassemble the components from 'a' to 'f' described in paragraph 5.2
• unscrew the screw V (fig. 19) and remove the cover C (fig. 20)
• remove the lamp and replace it with one of the same kind
• mount again all the components in reverse
D
5.3
DAS AUSTAUSCHEN DER UV- LAMPE
Die Lampe muss nach 6000 Funktionsstunden (circa 8 Monaten)
ausgewechselt werden.
Das Ganze darf nur von qualifiziertem Fachpersonal durchgeführt werden.
• Einweg-Schutzhandschuhe aus Latex tragen, und das Berühren der Lampe zu
vermeiden. Der Kontakt mit den Substanzen der Haut könnte die Lebensdauer
der Lampe drastisch beeinträchtigen
Das Austauschen der Lampe:
• Das Abbauen der Teile wie in den Schritten "a" bis "f", wie im Paragraph 5.2
befolgen.
• Die Schraube V (Abb. 19) lösen und den Deckel C (Abb. 20) entfernen.
• Die Lampe herausdrehen und mit einer Lampe vom gleichen Typ ersetzen.
• Die Teile in umgekehrter Reihenfolge wieder montieren.
F
5.3
SUBSTITUTION LAMPE UV
La lampe doit être remplacée toutes les 6000 heures (environ 8
mois) de fonctionnement.
Cette opération ne peut être effectuée que par un technicien qualifié.
• Enfiler des gants de protection en latex jetables pour éviter de toucher
la lampe avec les mains; le contact avec les substances de la peau peut
compromettre drastiquement la durée de la lampe.
Pour substituer la lampe:
• Démonter les parties décrites dans le paragraphe 5.2 de "a" jusqu'à "f".
• Dévisser la vis V (fig. 19) et enlever le couvercle C (fig. 20).
• Démonter et substituer la lampe avec une du même type.
• Remonter toutes les parties à rebours.
E
5.3
SUSTITUCIÓN LAMPARA UV
La lámpara debe ser sustituida cada 6000 horas
(aproximadamente 8 meses) de funcionamiento.
Esta operación debe realizarse por personal técnico cualificado
• Ponerse guantes protectivos desechables de látex para evitar tocar la
lám-para con las manos; el contacto de las sustancias con la piel puede
com-prometer drásticamente la duración de la lámpara.
Para sustituir la lámpara:
• Cumplir el desmontaje de las parte descritas en el párrafo 5.2 desde "a"
hasta "f".
• Desmontar el tornillo V (fig. 19) y quitar la tapa C (fig. 20).
• Desmontar y sustituir la lámpara con otra del mismo tipo.
• Volver a montar todas las partes al revés
Attention! direct irradiation of the UV lamp is dangerous both
for the eyes and for the skin
Achtung! Die direkte Bestrahlung der UV-Lampe ist für Augen und
Haut schädlich.
Attention! l'irradiation directe de la lampe UV est dangereuse
pour les yeux et pour la peau.
¡Cuidado! La irradiación directa de la lámpara UV es peligrosa
para los ojos y para la piel
25

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für Connect 28 WG

Inhaltsverzeichnis