Physio Stim Orthofix 5302CE Bedienungsanleitung Seite 8

Follow these steps to recharge the battery:
1. Open the Charging Port Cover.
2. Plug the Charging Connector into the Charging Port located on the
Control Unit. Be sure to align the angled corners of the power supply
connector to the angled corners of the connector inside the control unit.
3. Plug the power supply into any standard AC Wall Outlet. Do not plug in
the power supply for the PhysioStim device where it will be difficult to
unplug.
4. The Control Unit LCD will display a battery symbol filling to verify that the
device is charging. When the battery reaches a complete charge, a check
mark symbol will be displayed next to the battery symbol. In addition, the
device will beep once to alert the patient.
5. If the battery is fully depleted, it may require up to 4 hours to charge
completely.
6. After charging is complete, remove the Charging Connector and replace
the Charging Port Cover.
AC Power Supply
AC Charging Connector
Angled Corners
Charging Port Cover
5