Promate Aurora-200 Handbuch Seite 5

English
Operation Instructions:
1. Charging Aurora-200
• Charge Aurora-200 using the power adaptor provided.
• The Battery Level Indicators will light up indicating that Aurora-200 is charging
normally.
• When all the Battery Level Indicators light up, Aurora-200 is fully charged.
2. Checking the Remaining Battery in Aurora-200
• To check the remaining battery left in Aurora-200, briefly press the Power
Button. The Battery Level Indicators will light up indicating the amount of battery
left in Aurora-200.
No of LED's Active
% of power remaining
3. Powering Aurora-200 On/Off
• Press and hold the Power Button for about 3 seconds to turn Aurora-200 On/Off.
• Allow Aurora-200, 15-30 seconds to startup and make image adjustments.
• Initially, when turned on, you will see the Aurora-200 startup screen. The screen
may flicker briefly as DLP IntelliBright technology, built into the projector, will make
adjustments according to the ambient light in your surroundings.
Note: Before you switch on the projector, kindly be sure to check that there is nothing blocking the
ambient light sensor on the front of the projector. Blocking the sensor may impact the IntelliBright
adjustments the projector makes which optimizes the projected image.
4. Adjusting the Focus
• Slide the Focus Slider forward and backward on the Aurora-200 to fine-tune the
projected image.
5. Adjusting the Vertical Keystone
• Press the Mode Button and the projector will automatically adjust the display
screen to the best condition (+/- 40 degrees automatic vertical keystone
correction)
1
2
<=50%
<=25%
3 4
<=75% <=100%
4