Instructions For Use; Before Initial Operation; Inserting/Replacing The Battery - Flex MXE 18.0-EC Bedienungsanleitung

MXE 18.0-EC

Instructions for use

WARNING!
Remove the battery before carrying out any
work on the power tool.

Before initial operation

Unpack the mixer and check that there are
no missing or damaged parts.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge
the batteries fully. Refer to the charger
operating manual.

Inserting/replacing the battery

 Press the charged battery into the power
tool until it clicks into place.
 To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; explosion and fire
hazard!
Battery state of charge
 Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
NOTE
Follow the instructions for charging the
battery set out in the charger operating
manual.
Mounting/changing the mixer
paddle
Tool with spindle lock
 Press the lock and turn the gear selector
switch in anti-clockwise direction to
 Bolt the paddle onto the drive
spindle (2.).
 Tighten the mixer paddle with an open-
end spanner AF 22 (3.).
Remove in the reverse order.
(1.).
15