Taurus VIRAGE ACTIVE Handbuch Seite 14

- The cable housing means you can remove and
have available the required length of cable for
working with the appliance, preventing accident
risk situations.
- Clean the appliance.
CARRY HANDLE/S:
- This appliance has a handle on the upper
part of the body, which facilitates comfortable
transportation (H).
PARKING POSITION:
- This appliance has its own parking position for
comfortable and straightforward storage.
- To make use of the horizontal parking hook the
head's hook onto the hook that is to be found
on the lower part of the appliance. (Fig. 3).
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
EMPTYING THE DUST BOX
- Empty the dust container after each use of the
vacuum cleaner.
- Disconnect the hose from the vacuum cleaners
air intake. (Fig. 4).
- Disconnect the dust box from the appliance.
(Fig. 5).
- Open the lid of the dust box and empty the
contents into the appropriate waste disposal
receptacle. (Fig. 6).
- Check the condition of the motor filter.
- Close the lid of the dust box.
- Attach the dust box to the appliance.
- Connect the hose to the vacuum cleaners air
intake. (Fig. 1).
CHANGING THE FILTERS:
- Motor filter, it is advisable to periodically check
the state of the filter, which should be cleaned/
replaced after every 50 hours of use.
- HEPA type air outlet filter (high efficiency air
filter which effectively removes spores, ash,
dust mites, pollen ...), it is advisable to period-
ically check the condition of the filter, it should
be cleaned/replaced after every 50 hours of
use, or if a significant drop in suction power is
noticed
TO REMOVE THE FILTERS:
MOTOR FILTER:
- Disconnect the dust tank from the appliance.
(Fig. 4).
- Open the cover (R) that contains the filter and
extract the filter (Q1). (Fig. 7).
- Remove the HEPA filter (Q2) from its housing
by rotate it as the arrowhead show. (Fig. 8).
- Rinse the HEPA filter in the lukewarm water
and dry it during 24h.
- To reassemble the filter, proceed with the
above instructions, in reverse order.
OUTLET FILTER:
- Rotate the grill outlet filter as the arrowhead
show. (Fig. 9).
- Remove the filter (P) from its housing. (Fig. 8).
- To reassemble the filter, proceed with the
above instructions, in reverse order.
SUPPLIES
- Supplies can be acquired from distributors
and authorised establishments (such as filters,
etc...) for your appliance model.
- Always use original supplies, designed specifi-
cally for your appliance model.
- These supplies are available in specialist
shops.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.