CANGAROO NS30K03AP-H Benutzerhandbuch Seite 13

A. For warming feeding bottles of all sizes and brands and jars with food
1.) Fill the warmer with 100 – 120 ml water when preparing to warm feeding bottle and a little less for
food jars.
2.) Put the bottle/ jars in the warmer.
3.) The water should never flow over the bottle!
4.) Never fill more than 120 ml of water!
5.) Plug the unit into an electrical power outlet and turn the knob into the following setting:
6.) LED light with get red.
7.) During the warming procedure, LED indicator for heating is flashes, showing that the water around
the bottle/bowl reaches the temperature, needed to warm the content of the bottle/bowl.
8.) When the LED indicator for heating turn off, this means that the desired temperature is reached.
LED indicator for turning on/off will turn on when this for heating turn off.
9) When you have taken out the bottle/bowl, turn off the device from the socket as safety measure.
Turn the adjustment button on position STOP, for turning the device off.
10.) Always before feeding Your child, shake the bottle carefully and check the temperature of the
milk by sprinkling a few drops onto your wrist.
11.) And when warming jar with food before feeding the baby, stir the food and taste if it is too hot.
12.) Be careful not to overheat the milk/ food.4
B. For warming baby food:
1.) Put the baby food (such as cereal, congee or soup etc.) in the included in the set bowl.
2.) Fill the warmer with 100 ml of water.
3.) Never fill the unit with too much food in order it not to overflow.
4.) Put the bowl with food on the warmer.
5.) Plug the warmer to electric power outlet and put the knob in the following position:
6.) LED light with get red.
7.) During the warming procedure, LED indicator for heating is flashes, showing that the water around
the bottle/bowl reaches the temperature, needed to warm the content of the bottle/bowl.
8.) When the LED indicator for heating turn off, this means that the desired temperature is reached.
LED indicator for turning on/off will turn on when this for heating turn off.
9) When you have taken out the bottle/bowl, turn off the device from the socket as safety measure.
Turn the adjustment button on position STOP, for turning the device off
8.) Before starting to feed Your child, stir the food carefully and try if it is too hot.
10.) Warning! Do not warm the food for a very long time.
C. Sterilizing small feeding accessories (high temperature)
1.) Fill the warmer with 30 ml water.
2.) Put small articles such as pacifiers or teats into the warmer.
3.) Plug the unit into an electrical power outlet and turn the knob into the following setting:
4.) The LED indicator will turn on in red light.
5.) The sterilization will end after 3 minutes. Please, immediately turn the adjusting button to position
STOP for turning the device off.
Note: Working under high temperature will lead to easier damage of the unit. In order to
prolong its life, please, do not use this function too often!
ATTENTION: The warmer will continue to heat until you turn the adjustment button on position STOP
or you turn it off the socket.
Recommendations:
- The temperature in the water will decrease with few degrees, when the powdered milk get poured
into the bottle with water.
- The temperature of the water can influence by the high or low initial temperature.
Note: Wait for 1 minute before taking the bottle/bowl out of the warmer, so it can cool and to avoid the
risk from burning.
12