Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before you start
1. L-wrench
1. Adjusting knob
2. Guide wheel
3. Numbers
4.
Firmly tighten the shaft bolt. Remove the L-wrench.
The edger is designed for use with the blade only.
Never operate the edger without the cutting attachment
shield installed and tightly secured.
Adjusting blade cutting depth
The edger's depth of cut is controlled by a combination of opera-
tor height, blade wear, and the positioning of the edger's guide
wheel.
To adjust blade height:
1.
Loosen the guide wheel adjusting knob.
2.
Raise or lower the guide wheel to the desired setting.
3.
Tighten the guide wheel adjusting knob firmly.
Use only shindaiwa replacement blades.
Never adjust the guide wheel while the engine is run-
ning.
NOTE
Guide wheel adjustment is also required to compensate for
blade wear.
The numbers are for reference only; they do not refer to
depth in inches.
12
WARNING
WARNING
Werbung
Kapitel
Inhaltsverzeichnis
