Before You Start; Assembly - Shindaiwa SBA-LE24 Bedienungsanleitung

Before you start

Assembly

Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
Installing a Tool Attachment
1. Multipurpose engine
2. Latch protector (ex-
tended)
3. Latch
4. Coupler screw knob
1. Coupler
2. Latch protector (low-
ered)
Disassembling the Tool Attachment
1. Press latch
WARNING
5. Coupler
6. Locking hole
7. Splitboom attachment
3. Coupler screw knob
Before you start
1. Place Multipurpose Engine and the Splitboom Attachment
on a clean, flat surface so that both assemblies fit end to
end. The powerhead assembly should be facing up, and the
Splitboom Attachment should be positioned with the locking
hole in the tube end facing up.
Keep the open ends of the tubes clean and free of debris.
2. Slip off the protective cover from the end of the tool, and
loosen the coupler screw knob.
3. Insert the tube into the coupler, with the tool decal facing up,
until the line of the decal is flush with the end of the coupler.
Twist the tool back and forth until you are sure it snaps in
place by the coupler latch.
4. When the two tube halves are locked together, press down
on the spring-loaded latch protector and tighten the coupler
screw.
Make sure there is no gap between the Latch protector and
the coupler.
1. Place the unit on a clean, flat surface, loosen the coupler
screw. The spring loaded coupler protector should pop up.
2. Press down on the latch with your finger or thumb. This re-
leases the coupler lock.
3. Pull the tube out of the coupler.
10
CAUTION
CAUTION