Pioneer DR-R7181 Bedienungsanleitung Seite 7

A HARDWARE TOUR
1 2 34
ON
SCSI ID
8
1 SCSI termination switch
This switch is used to turn the drive's
internal SCSI termination switch on and off.
Note that this switch is set on at the time of
shipment.
2 Parity switch
When the parity switch is turned on odd
parity checking is performed by the CD-R
drive for all data read in from the SCSI data
bus, and when the parity switch is turned
off no parity checking is performed. Note
that a parity bit is assigned to each byte of
output data transmitted from the CD-R drive
whether the parity switch is turned on or
off.
3 Termination indicator
When the drive is installed in a changer and
its power cable has been connected, this
indicator lights up if the drive's SCSI
termination switch has been turned on.
4 Wiring monitor indicator
Meaning of indicator when indicator is
lit up:
Indicates that a disc has been inserted
into the drive.
This indicator also lights up when the
drive is installed in a changer and its
power cable has been connected.
Meaning of indicator when indicator
flashes in 2-second intervals:
This indicator flashes in 2-second
intervals when the drive is installed in a
changer and its changer interface cable
has been connected.
5
WIRING MONITOR IND
SCSI TERM IND
PARITY ON / OFF
TERM ON / OFF
6
RELEASE LOCK
9
Meaning of indicator when indicator
flashes in 0.5-second intervals:
This indicator flashes in 0.5-second
intervals when the drive in question has
been specified as the drive to be
swapped during the swapping of drives.
5 Changer interface cable
This cable must be connected to the
c h a n g e r- i n t e r n a l c h a n g e r i n t e r f a c e
connector.
6 Power cable
This cable must be connected to the power
inlet located in the changer.
7 Lock lever
When a drive is to be removed from the
changer, flip the lock lever to the released
position and then pull the drive out from the
changer.
8 SCSI ID switches
These switches are used to set the drive's
SCSI ID. Pressing the upper switch causes
the displayed SCSI ID to be decremented,
and pressing the lower switch conversely
causes the SCSI ID to be incremented. Note
that SCSI ID is set to '0' at the time of
shipment.
9 SCSI interface connector
This connector must be connected to the
SCSI cable provided with the changer or to
an add-on SCSI cable.
NOTE:
Be careful not to allow any part of your body
to come into contact with connector pins,
as doing so may result in faulty connections
or damage from static electricity.
7
7
<DRC1111>
En