Troubleshooting - SCOPREGA GE OV 10 Bedienungsanleitung

TROUBLESHOOTING

Problem Possible cause
Cable not connected.
ON/OFF switch on (0).
Inflator will not start.
D a m g a d e c
Thermal protection has switched off
the inflator.
Cable disconnected.
Inflator does not
Thermal protection has switched off
operate.
the inflator.
Wrong connection of the inflation
hose.
The inflatable does not
reach the target
Wrong connection of the inflation
pressure value.
fitting.
ACCESSORIES
Recommended accessories for use with your inflator are available at your local dealer or authorized Service Centre
WARNING!
The use of any accessories not recommended for use with this inflator could be hazardous.
Connect the cable to the power supply.
Set the ON/OFF switch on (I).
b a . e l H v a t e e h
Normal operation is restored once the unit has cooled down.
If the problem continues, contact a SCOPREGA Service Centre.
Connect the cable to the power supply.
Normal operation is restored once the unit has cooled down.
If the problem continues, contact a SCOPREGA Service Centre.
Connect the inflation hose properly.
Connect the inflation fitting properly
Possible solution
c b a e l e r l p c a d e y b a S C O P R E G A S e i v r e c C n e r t . e