Operating Elements And Connections - Monacor AV-410SET Bedienungsanleitung

Please unfold page 3. Thus you will always be able
GB
to see the operating elements and connections
described.
1

Operating Elements and Connections

1.1 Transmitter
1 BNC plug for plugging onto the video output jack of
a camera
2 Transmitting antenna
3 12 V connection cable between camera and trans-
mitter
4 Microphone
5 Channel switches
1
2
channel 1
2.414 GHz
6 Low voltage jacks (5.5/2.1 mm inside diameter/pin
diameter) for connection of a 12 V power supply unit
and for passing on the supply voltage to the camera
1.2 Receiver
7 Reception antenna
8 Antenna connection (SMA jack)
9 LEDs for indicating the adjusted channel
10 Button SET for channel adjustment
8
channel 2 channel 3
2.432 GHz 2.450 GHz
11 POWER switch
12 Connection jack DC12V for the supplied plug-in
power supply unit
13 AUDIO output (phono)
14 VIDEO output (phono)
15 Low voltage plug of the power supply unit
2 Safety Notes
The units (transmitter, receiver, and plug-in power sup-
ply unit) correspond to the directive for electromagnetic
compatibility 89/336/EEC. The plug-in power supply
unit additionally corresponds to the low voltage direc-
tive 73/23/EEC.
WARNING The plug-in power supply unit is supplied
channel 4
2.468 GHz
Please observe the following items in any case:
The transmitter must not be operated near cardiac
pacemakers (minimum distance 25 cm) and medical
appliances. The electromagnetic radiation may lead
to interference.
The units are suitable for indoor use only. Protect
them against high air humidity, dripping water and
splash water, and extreme temperatures (admissible
ambient temperature range -10 °C to +50 °C).
with hazardous mains voltage (230 V~).
Leave servicing to skilled personnel only.
Inexpert handling may cause an electric
shock hazard.