Dea NET24N Bedienungsanleitung Und Hinweise Seite 44

3 Selection type of operators
1. Scroll down the parameters with
lise P028;
2. Access the parameter by pressing the
3. Acting on and
Type 00 Type 01
• 005 5/24 • 000 Geko - An-
• 006 8/24 golo
• 007 Rev • 001 Look - Mac
- Sting
• 002 Ghost
• 003 Livi 500 -
502 - 550PL
Warning: If you are using non DEA System operators, set the parame-
ter on the closer value for family type and performances (refer to table
on page 31).
4. Confirm your choice by pressing the
to P028).
4 Selection operating with or without encoder
Warning: Remember to correctly set the jumpers J5 and J9.
1. Scroll down the parameters with
lise P029;
2. Access the parameter by pressing the
3. Acting on and
- d000=for operators with encoder;
- d001=for operators without encoder;
4. Confirm your choice by pressing the
to P029).
5 Selection 1 or 2 operators functioning
1. Scroll down the parameters with
lise P030;
2. Access the parameter by pressing the
3. Acting on and
- d001=for a single motor operating;
- d002=for 2 motors operating;
4. Confirm your choice by pressing the
to P030).
6 Selection of direction of motion (only Type 00 and Type 03)
1. Scroll down the parameters with
you visualise P063;
2. Access the parameter by pressing the
3. Acting on and
- d000=motor in standard position;
- d001=motor in inverted position;
4. Confirm your choice by pressing the
returns again to P063).
Warning: The parameter automatically reverses the
motors output open/close.
Warning: Changing this parameter you need to change
the parameters for the opening and closing limit switches.
42
! IMPORTANT !
and keys until you visua-
key;
keys, set:
Type 02
• 003 Livi 902/24 - • 003 Pass
905/24 • 004 Stop
key (display returns again
and keys until you visua-
key;
keys, set:
key (display returns again
and keys until you visua-
key;
keys, set:
key (display returns again
and keys until
key;
keys, set:
key (display
Type 03
! IMPORTANT !