Adjusting The Display; Factory Presets, Auto-Sync, And User Settings; On Screen Display (Osd) Settings - Wacom DTF-720 Installationshandbuch Und Benutzerhandbuch

ADJUSTING THE DISPLAY

FACTORY PRESETS, AUTO-SYNC, AND USER SETTINGS

Factory presets: For optimal display quality, set your video card to the DTF-720's native resolution of
1280 x 1024 pixels. See page 50 for signal specifications.
Auto-sync: The DTF-720 attempts to automatically synchronize to the incoming signal. Auto-sync will
function when the horizontal frequency is between 30 to 80 kHz and the vertical frequency is between
50 to 75 Hz. If the DTF-720 does not automatically synchronize with the incoming signal, you can use
the On Screen Display (OSD) R
screen display adjustments can be manually made using the OSD controls.
User settings: When you manually set the display using the OSD function, the settings are stored
within the DTF-720 for use the next time the unit receives a similar signal. This is applicable to all
display modes.

ON SCREEN DISPLAY (OSD) SETTINGS

The OSD function enables you to adjust and optimize a variety of display settings at the touch of a
button. The OSD controls are located on the upper left edge of the unit.
Menu button
Opens or closes the OSD menu.
The basic process for working with the OSD is as follows:
•
Press the M button to open the OSD main menu.
ENU
•
Use the + or – buttons to select an option. When the option you want to adjust is highlighted,
press the E button. The current settings and adjustment sub-menu for that option will appear.
NTER
•
Use the + or – buttons to adjust the option settings.
•
After making your changes, press the E
Note: All settings are automatically saved when the OSD menu closes. If you make changes to the display
appearance and cannot return to the original settings, use the
its original factory defaults.
Customizing
Page 28
A A option to initiate display synchronization. Further
ESET UTO DJUST
–
Selection buttons
Use these buttons to select an option that can be activated
when you press the E
option, press the + button to increase a selected item value,
and press the – button to decrease it.
button to save. To exit, press the M
NTER
+
E button
NTER
Activates or deactivates the
selected OSD menu option.
button. After activating a selected
NTER
R R
option to return the DTF-720 to
ESET ECALL
button.
ENU