Lcd Monitor Cabling Diagram - Wacom DTF-720 Installationshandbuch Und Benutzerhandbuch

LCD MONITOR CABLING DIAGRAM

DTF-720, rear view
The RGB-O port is used to connect
UT
a second VGA device such as a
projector or monitor that mirrors the
pen display. Be sure to fully install the
DTF-720 hardware and software
before connecting a projection device
to the unit. Do not connect or
disconnect any cable while the
DTF-720 or your computer are turned
on.
C
Use only the power adapter that came with the DTF-720; use of an improper power adapter
AUTION
may damage the unit.
Do not connect or disconnect the video or power cables while the DTF-720 or your
computer are turned on – this can damage the display or computer video card.
Make sure that the display refresh rate does not exceed 75 Hz.
Installation
Page 12
– B –
DC IN
(12V)
– A –
VGA cable
Video card
VGA port
Rear panel of your computer
Power adapter – C –
Do not attach the
USB data cable until
instructed to do so.
RGB-I
N
RGB-O
UT
To AC outlet