Troubleshooting - Stryker CrossFlow Handbuch

3
4
3� Press the black foot pedal (highlighted with a green border) to select its function�
4� Press Up and Down
5� Press the function of choice to assign the function to the pedal�
In this scenario, the "Wash" function is selected�
6� Repeat steps 3–5 to program the red foot pedal�
7� Press Close Pump Customization Menu

Troubleshooting

Problem
The footswitch is plugged in,
but is not activating�
EN-8
to scroll up and down the function list�
to close the Pump Customization Menu�
Cause
The footswitch is improperly
connected to the pump�
The settings in the
Footswitch/CrossFire 2 Shaver
Settings Menu are set to
"None� "
The footswitch has reached
its expected lifetime�
Possible Solution
• Ensure the footswitch
is properly connected
according to the
instructions in the
"Setup and Device
Configuration" section of
this manual�
• Check the settings in the
Footswitch/CrossFire 2
Shaver Settings Menu�
• Reset the settings to the
Default settings�
• Replace the footswitch�
5
6
7