Watchguard Firebox M270 Kurzanleitung Seite 3

About the Firebox Status Lights
Indicators for RJ45 interfaces
Interfaces 0 - 7 each have two indicators. The right indicator shows the interface connection status.
The left indicator shows interface activity.
Indicator Indicator color
Connection (right) Yellow
Green
Not lit
Activity (left) Yellow, blinks
Not lit
Storage (
) – When there is activity on the mSATA card or hard disk, the storage indicator is yellow.
Arm/Disarm (
) – When the Firebox is armed and ready to pass traffic, this indicator is green.
When the Firebox is powered on, but not ready to pass traffic, this indicator is red.
Power (
) – The power indicator on the left front of the Firebox is green when the Firebox is
powered on.
Power Button (
) – The Power button on the front of the Firebox is lit to indicate power status. It is
green when the Firebox is powered on, and red when power is available, but the Firebox is powered
off. When the Power button is red, press this button to power on the Firebox. When the Power button
is green, press and hold it for five seconds to power off the Firebox.
4
Interface Status
Link at 1000 Mbps
Link at 100 Mbps
Link at 10 Mbps or no link
Power on, network activity
Power off, no connections
Install Your Firebox
For instructions to install your Firebox in a network rack, see the Firebox M270 Hardware Guide.
Reset the Firebox to Factory-Default Settings
If you ever need to, you can restore your Firebox to its factory-default settings. For example, if you do
not know the administrator account passphrase or you want to start over with a new configuration,
you can reset your Firebox. Make sure you back up your Firebox configuration before you reset your
Firebox in case you want to restore it in the future.
For information about how to reset your Firebox, see the Firebox M270 Hardware Guide,
available at: www.watchguard.com/help/documentation/hardware.asp
5