Useful Information; Commissioning; Working With Wireless Controller (Wico) - IKA WiCo LR 1000 control Betriebsanleitung

Useful information

The WiCo is equipped with a USB socket (Universal Serial Bus)
with which the WiCo can be connected with station, the USB
icon appears on the screen.
If the WiCo is not connected with station via a USB cable, the
data exchange between the station and the WiCo via Blue-
tooth . In this case, the Bluetooth
®
Depending on the structure of the building, the WiCo can be
operated at a distance up to 15 m from the station, using the
Bluetooth ® connection.

Commissioning

Check whether the voltage given on the type plate corresponds to
the available mains voltage.
The socket used must be earthed
(fitted with earth contact).
If these conditions have been met, the machine is ready for opera-
tion when the mains plug is plugged in.
If these conditions are not met, safe operation is not guaranteed
and the machine could be damaged.
Observe the ambient conditions (temperature, humidity, etc.) listed
under "Technical Data".
The battery in the Wireless Controller (WiCo) must be charged by
the power supply adapter before the first use of the device.
The battery could also be charged via the USB port on the WiCo
(See "Charging the Battery Pack RB 1" in "Preparations" section).
icon is displayed.
®
First use information (e.g. RET control-visc)
1) Connect WiCo to station via USB cable
USB Micro B
2) Switch on station and WiCo
3) Follow the instructions on the WiCo screen
4) Devices will connect automatically after few seconds
5) Remove the USB cable after successful connection for wireless
control
Working with Wireless Controller
After switching on the WiCo the operating control changes over from
the station screen to the WiCo screen. If the WiCo is switched off the
operating control changes back to the station screen.
NOTICE
• Emergency-Stop is always possible at the station.
• When operating, please refer to the operating instructions of
LR 1000 control and RET control-visc.
USB Micro A
15