Removing The Car Seat - VERTBAUDET KidsIt+ Isofix 1-2-3 Bedienungsanleitung

against the vehicle seat and then feed the diagonal strap of the belt through the headrest
guide (26).
Sit your child in the car seat. The lifting armrests make it easier for you to seat the child and put
on the harness. Make sure that the child's back is fully in contact with the back of the car seat.
Pull and fasten the vehicle seat belt. Pass the diagonal strap of the belt under the armrest op-
posite the belt guide used. The waist strap of the belt passes under both armrests (27). Lower
the adjustable headrest and adjust it to the height of your child (28). It should be positioned
so that it surrounds your child's head, providing maximum lateral protection, whilst guiding
the diagonal belt over the child's shoulder so that there is no contact with the child's neck (29)
(30). Tighten the vehicle seat belt.
Ensure that the belt is properly tightened, that it is not twisted and that it is not at the level
of your child's neck.
To remove your child from the car seat, simply unbuckle the seatbelt and place it at the side
of the car seat. The belt will remain suspended from the headrest belt guide. IMPORTANT:
Before each journey, check that the armrests have been lowered. Secure your car seat with the
vehicle seat belt at all times, even when your child is not in the car seat. An unsecured car seat
can cause injuries in the event of a collision.

Removing the car seat

Step 1 (Group 1): Loosen the Top Tether strap by pressing the button on the tensioner (31),
then release the strap from its anchor point and bring it towards you (32).
Step 1 (Group 2/3): Remove the diagonal strap of the seatbelt from the belt guide of the
adjustable headrest (33).
Step 2 (all groups): Pull the car seat using the red handle on the ISOFIX base (34). On either
side of the seat, release the ISOFIX connectors from their anchor points by pulling the release
buttons towards you. The indicators will turn from green to red (35) (36). The car seat can now
be removed (37).
Returning to the original configuration of the car seat
Follow the instructions below if you wish to return to the harness configuration.
Re-install the crotch strap, making sure that the metal keeper is correctly in place under the
seat (38). Via the front of the backrest, between the cover and the shell, grasp and twist the
metal anchor of one of the two other sections of the harness, simultaneously pulling the sec-
tion through from the back (39). Feed the harness section through the side openings of the
shell and cover and re-install it via the front of the backrest at the desired height (40). Make
sure the metal anchor of the harness section is correctly in place behind the backrest (41).
Repeat the procedure with the second section of the harness. Make sure the harnesses are
not twisted.
Re-install the Top Tether strap, passing it between the backrest and the car seat cover. Make
sure that the metal anchor is correctly in place behind the backrest (42).
20
User guide