From Wheelchair To Vehicle - Autoadapt CARONY GO! Benutzerhandbuch

4. FROM WHEELCHAIR TO VEHICLE

1. Reverse the wheelchair
Reverse the wheelchair towards the
turned out swivel base Turnout or
the lowered car seat lift Turny.
1
4. Adjust the seat height
Level the seat height to the rails in the vehicle.
The height is adjusted by first pressing the seat lift
button, marked 1, and then by moving the joystick
forwards or backwards.
6. Transfer the seat
Release the seat from the wheel unit by pulling down the
seat release placed at the front of the seat. Slide the seat
over to the vehicle until it locks in the inner position.
Make sure that the seat release handle has returned to
original position and that the seat is unable to slide forward.
Check this!
20
2. Disengage the motors
Disengage the motors by pulling the
handle, placed on the left side of the
wheelchair, forward.
2
Height adjust to
compensate move-
ment of weight!
3. Move the wheelchair manually
Move the wheelchair towards the swivel
base.
5. Lock
Push the wheelchair towards the rails in the vehicle.
The covers of the clutch open automatically. Push until it
connects properly to the vehicle rails.
Make sure the units have been properly connected by
trying to pull them apart.
7. Release the wheel unit
Release the wheel unit from the vehicle by pulling up
both lock handles.
Swivel the seat inside the vehicle/drive the seat lift up
and inside.
Engage the motors. Turn off the power and load the
wheel unit in the vehicle luggage compartment and
secure it.