To select a different language, follow the following steps.
Select Setup from the top bar (01). Select General from the left menu (02). Select the desired language in the
web interface (03).
Fig. 27
10 Instructions for normal
operation
10.1 Enabling the wiper (Wiper)
Do not use the wiper if the outside
temperature is below 0°C or in case of ice.
To activate/deactivate this function, refer to the
manual of the control device used or to the relative
chapter (10.3 Special controls, page 26).
10.2 Enabling the washer
(Washer)
To activate/deactivate this function, refer to the
manual of the control device used or to the relative
chapter (10.3 Special controls, page 26).
26
01
03
10.3 Special controls
Fig. 28
SPECIAL CONTROLS
Action
Run wiper once when system calls the
preset.
Run washer once when system calls the
preset
Tab. 5
03
Preset
103
112
Document 800-23313 Rev. A