Bracket Mounting; Fixing The Unit To The Pole Mount Adapter Or Corner Mount Adapter; Fixing With Pole Mount - Honeywell HEPZ Series Bedienungsanleitung

5.5.2 Bracket mounting

The bracket can be fixed to the vertical wall. Use
screws and wall fixing devices that can bear at least
four times the weight of the unit.
To fix the device to the bracket, use 4 plane washers,
4 stainless steel grower washer, 4 socket head
stainless steel screw provided.
Fig. 6
Make sure the thread are free of dirt and debris.
Apply a generous amount of thread locking
compound (Loctite 270) on the 4 screws.
Tighten the screws.
Pay attention to the fixing. Tightening
torque: 35Nm.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
12
5.5.3 Fixing the unit to the pole mount
adapter or corner mount adapter
To install the product on a pole or at a wall corner,
first of all fix the unit to the wall bracket (5.5.2 Bracket
mounting, page 12).

5.5.3.1 Fixing with pole mount

Fix the wall bracket to the pole mount adapter
using 4 washers, 4 stainless steel grower washer
and 4 hexagon stainless steel bolts (A4 class 80)
M10x30mm.
Fig. 7
Make sure the thread are free of dirt and debris.
Apply a generous amount of threadlocker (Loctite
270) on the 4 threaded holes on the pole mount
adapter.
Tighten the screws.
Pay attention to the fixing. Tightening
torque: 35Nm.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
Document 800-23313 Rev. A