Stryker 240-099-110 Betriebs- Und Wartungsanleitung Seite 6

Assembling the Roll Stand
1. Using the 3/16'' T-handle hex key provided, remove two (2) 1/4-20 x 3/4'' SHCS and lock washers from end of Post.
2. Insert bottom end of Post in Base, ensuring locator pin is seated in slot provided (photo below left). Lay Roll Stand on
its side for attachment of Foot Pedal Assembly.
3. Align the two (2) mounting holes in the Foot Pedal Assembly with the two (2) threaded mounting holes in the bottom of
the Post. Using the 3/16'' T-handle hex key, secure the Pedal Assembly to the Post with two (2) 1/4-20 x 3/4'' SHCS.
Set Roll Stand upright for attachment of Handle and mounting of flat panel display.
Locator Pin
6
Post
Base
Foot Pedal Assembly
1/4-20 x 3/4'' SHCS (2)
Lock Washers (2)