Possible Cause; Section Viii. Trouble Shooting - Wachs TC 4.5 Bedienungsanleitung

TUBE CUT OFF SAW TC 4.5
TC 4.5 TROUBLE SHOOTING
SECTION VIII
Trouble

Possible Cause

Remedy
Motor Will Not Run .......................... Power Unit Not Connected ............................. Check Power Cord & Connection
Motor Runs Slowly .......................... Improper Speed or Gear Box Setting ............. Refer to Speed Control & Gear Box Info.
Difficult Rotation Resulting In ......... Dull or Chipped Saw Blade .............................. Replace Saw Blade
Poor Workpiece End Quality
Workpiece Rotates During Cut ......... Loose Vise Clamp ............................................ TIghten Vise Clamp
No Saw Blade Penetration .............. Saw Blade Depth Too Shallow ........................ See 'Setting Saw Blade Depth' Procedure
Machine Begins To Rotate .............. Saw Blade Depth Too Deep .............................. See 'Setting Saw Blade Depth' Procedure
Then Stops
Saw Blade Will Not Cut .................... Improper Saw Blade Direction .......................... Change Saw Blade Rotation Direction
Blade is constantly loosening.........Saw blade is dull. ............................................. Replace blade
12