Herunterladen Inhalt Inhalt Diese Seite drucken

Workpiece Clamping; Setting Blade Depth; Machining Instructions - Wachs TC 4.5 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

TUBE CUT OFF SAW TC 4.5
SECTION V
C.

Workpiece Clamping

1.
To open vise, rotate vise handle counter clock-
wise.
2.
Do not Damage blade or cut line indicator when
positioning workpiece in vise.
3.
Secure workpiece in vise, rotate handle clock-
wise.
D.

Setting Blade Depth

1.
Clamp workpiece in vise with end of workpiece
behind edge of blade. (Figure 5)
Figure 5
2.
Rotate cutter gear box 45° (clockwise) to en-
gage cutter gear box.
3.
Rotate cutter depth knob until blade penetrates
workpiece I.D. by 1/16". (Figure 6)
Figure 6
4.
Rotate cutter gear box 45° (counterclockwise)
to its start point.
5.
Blade depth will need adjustment as work di-
ameter is changed.
TC 4.5 SETUP & OPERATING PROCEDURES
E.

Machining Instructions

CAUTION: Beware of falling
pipe when cutting long lengths.
1.
Set speed control on back of motor, see chart on
page 11.
2.
Squeeze trigger on motor and lock trigger on.
(Figure 7)
Figure 7
3. Use motor handle to rotate cutter gear box clock-
wise (Figure 8).
Figure 8
4. Rotate cutter gear box clockwise 360°.
5. After completion, squeeze trigger on motor to re-
lease lock on trigger.
CAUTION: NEVER lubricate Vise Screw.
Lubrication can loosen vise while cut-
ting causing danger to the operator.
9
(CONT.)

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis