Sony SVT-72P Bedienungsanleitung Seite 11

RS-232C/RS-485 Interface
When the personal computer is connected to the RS-
232C or RS-485 connector, the transmission speed
(baud rate) can only be set using the GENERAL SET
menu.
1
Select the RS-232C or RS-485 connector to be
used using the RS-485/RS-232C switch at the rear.
2
Turn on the power of the equipment to be used.
3
Press MENU and MENU V until "4" of the MAIN
MENU flashes on the monitor screen.
4
Press MENU B.
The GENERAL SET menu appears.
GENERAL SET
TAPE IN MODE STOP
TAPE END MODE REW
TAPE USED COUNT OFF
CLOCK ADJUST 0 1 : 0 0
APC ON
THREAD CHECK OFF
T/D SEARCH CONVENTION
BAUD RATE 1 9 2 0 0
< >
NEXT PUSH
+
–
SELECT : DATA SET : / RETURN : MENU
5
Press MENU V to move the flashing to BAUD
RATE and set the baud rate (19200, 2400, 4800 or
9600 bps) by pressing MENU + or –.
CLOCK ADJUST 0 1 : 0 0
APC ON
THREAD CHECK OFF
T/D SEARCH CONVENTION
BAUD RATE 1 9 2 0 0
< >
NEXT PUSH
+
–
SELECT : DATA SET : / RETURN : MENU
6
Press SEARCH to return to the normal display.
11