Caberg Horus Handbuch Seite 6

ENG
Your helmet HORUS thanks to the double homologation P/J can be used in 2 configurations (chinguard
closed "P" and chinguard open "J")
Lever P/J
When the P/J lever is positioned on "J" it is possible to block the chinguard in the open position ( Pic.1).
WARNING ! When in "J" position it is not possible to close the chinguard. Do not force the clo-
sure, as this, could cause damages to the closing mechanism of the helmet.
To be able to close the chinguard it is necessary to move the P/J lever to the "P" position.
When the lever P/J is positioned on "P" the chinguard can be opened and closed (Pic.2)
WARNING!
- The level of protection of this helmet is in function of the configuration adopted by the user: full
protection with the chinguard closed and partial protection when the chinguard is open.
- Whilst on the move do not ride with the chinguard in the open postion if the P/J lever is not
positioned in the configuration "J"
1. HOW TO FIX AND REMOVE THE CLEAR VISOR
1.1 With the chin-guard closed, open the visor; Raise lever A and then release the visor (Pic. 3)
1.2 Repeat the same process on the other side and remove completely the visor.
To re-install the clear visor, place the pivot on the visor mechanism and slide it until it is hooked. (Pic. 4)
2. HOW TO REMOVE THE SMOKE SUNVISOR
2.1 Move the smoke sun visor lever towards the front of the helmet (Pic.5)
2.2 Release and remove the smoke sun visor by pulling gently outwards on both sides (Pic.6)
3. HOW TO FIX THE SMOKE SUNVISOR
3.1 Move the smoke sun visor lever towards the front of the helmet (Pic.5)
3.2 Insert and hook the visor to its seating by pressing gently on both lateral sides (Pic.7)
WARNING: never use the smoke sun visor during the night or with scarce visibility condition
WARNING: any adjustments to the smoke sun visor must be done with the two-wheeler in still position
6
HORUS