V2 LEX-RFO40-230V Bedienungsanleitung Seite 21

PROGRAMMING OF OPENING LIMIT SWITCH
OF THE ROLLING SHUTTER
To set the opening limit switch on a rolling shutter with
a blockage at the top, you must have a previously stored
transmitter available and must proceed with the following
points.
1. Supply power only to the control unit to be programmed
2. Activate the ARTEMIS programming
3. Press the UP or DOWN keys until the LED 3 lights up with solid
light and the others flash
4. Press and hold down the UP+DOWN keys until the motor
moves in both directions which confirms it is entering the
programming phase
5. Release the keys, the motor stops
6. Press the UP key: the roll-up shutter rises at a normal speed
7. Once in contact with the upper lock, it stops and memorizes
the position
8. To exit the programming mode press the STOP key
To set the opening limit switch on a rolling shutter without
blockage at the top, you must have a previously stored
transmitter available and must proceed with the following
points.
Repeat points 1,2,3,4,5 previously described
6. Bring the roll-up shutter to the upper position desired using
the UP and DOWN keys. To regulate it precisely, press the
UP+DOWN key when the motor is close to the end-of-stroke:
the motor will start to move in jerks
7. Press the STOP button when the desired position is reached
8. To exit the programming mode press the STOP key
PROGRAMMING OF CLOSING LIMIT SWITCH
OF ROLLING SHUTTER (CLOSED LOUVER
BLADES)
NOTE: you must have a previously stored transmitter
available and must proceed with the following points
1. Supply power only to the control unit to be programmed
2. Activate the ARTEMIS programming
3. Press the UP or DOWN keys until the LED 5 lights up with solid
light and the others flash
4. Press and hold down the UP+DOWN keys until the motor
moves in both directions which confirms it is entering the
programming phase
5. Release the keys, the motor stops
6. Bring the roll-up shutter to the LOWER position desired using
the UP or DOWN keys. To regulate it precisely, press the
UP+DOWN keys when the motor is close to the end-of-stroke:
the motor will start to move in jerks
7. Press the STOP button when the desired position is reached
8. To exit the programming mode press the STOP key
PROGRAMMING OF OPENING POSITION OF
ADJUSTABLE LOUVER BLADES
NOTE: you must have a previously stored transmitter
available and must proceed with the following points
1. Bring the roll-up shutter to the INTERMEDIATE position desired
2. Activate the ARTEMIS programming
3. Press the UP or DOWN keys until the LED 3 lights up with solid
light and the others flash
4. Press the UP+DOWN keys of the transmitter until the motor
confirms the storage of the intermediate position moving in
both directions for 1/2 seconds
5. Using the UP and DOWN buttons, open the louver blades to
the desired position. To perform a precise adjustment press
the PROG button when the motor approaches the desired
position, the motor will begin to move jerkily
6. Press the key STOP once reached the required position: the
motor stops and then proves the correct storage of the end-
of-stroke by moving for 1/2 second first upwards and then
downwards
7. To exit the programming mode press the STOP key
To bring the rolling shutter into the opening position of the
adjustable louver blades press the STOP button for at least
3 seconds (with the motor stationary): the louver blades
moves until it reaches the tracked position.
- 21 -