Technical Data - PIAB P3010 AVM 2 Anleitung

AVM™2

TECHNICAL DATA

General electric characteristics
Supply voltage
Maximum ripple
Power consumption
Maximum load on the outputs
MTBF (electronics)
Reversed polarity protection
Valve units
Function on/off
Function blow-off
LED status indicator, colour
Vacuum switches
Outputs
Vacuum signal levels
Hysteresis
Response time
Maximum overpressure
LED status indicator, colour
Limit value for air saving function (ES)
Other data
Blow-off capacity
Operating temperature
Materials
Degree of protection
Cable (accessory)
Humidity
22–28 VDC (typical 24 VDC)
1V , 50-60 Hz
RMS
Nom. 2.6 W @ 28 VDC (max. 7.5 W)
4040404 40 mA (short-circuit protected)
40,000 hours according to MIL-HDBK-217E
5 minutes at 23C [73.4F]
Normally closed (NC/NC 2) or normally open (NO)
Normaly closed (NC)
Red
2 digital, 24V, S1 and S2
See table in the section "setting of the vacuum-signal level"
Fixed 7 kPa ±1 kPa [2.1 inHg ±0.3 inHg]
<10 mS
0.7 MPa [101.5 psi]
Green
Level according to output S2
Adjustable 0–7.5Nl/s [0-15.9scfm]
0-50C [32-122F]
Al, PA, NBR, SS, PMMA, ABS
IP65 [NEMA 4]
2 and 5 m PUR
90% RH
33