The Control Panel; Troubleshooting - Marolex VX electric Gebrauchsanweisung

The control panel

Troubleshooting:

Symptoms:
Sprayer does not
work
Despite charging the
GB
sprayer, the control
panel does not light
up
Feeding valve R020j
leaking
Blocked trigger
button R44
Weak spraying
action although the
pressure in the tank
is high
22
Reason:
Swich button off
Discharged battery
Charger does not work
Defect in control panel
Loose hose nut R80e or
damaged gasket R47c
Freezing water ruptured
handle or valve.
Damaged valves cylinder
top gasket (it wasn't
lubricated periodically)
Lost seal R47c or
unscrewed lance
Trigger button is in
continuous work position
The valve's piston is
seized
R40 filter dirty
Clogged nozzle in the
lance
charging complete
charging in progress
switch button
charging socket
Solution:
Press the switch button on the
control panel
Charge the battery ("process" on the
control panel will show)
Buy new charger
Contact Marolex service
Tighten the nut or replace the gasket
R47c (found in repair kit Z08j or
washers kit Z08u)
Replace the valve & handle – R020j
Replace the piston with the o-rings
(found in kits Z08j and Z08z) or even
the entire R020j valve
Insert the seal R47c or screw the
Unblock the trigger button by
pressing it and moving backward
Replace the valve's piston (included in
kits Z08j, Z08z) or replace the entire
handle with valve R020j.
Unscrew the hose, remove the R40
filter and clean it or replace with
a new one (found in kits Z08j,
Z08b,R40)
Unscrew the nozzle cap R115, then
the nozzle nut R64, take out the
nozzle core R114 and rinse all parts
under running water; lubricate the o-
ring on the nozzle core and assemble