Equipment Maintenance; General Comments - Marolex VX electric Gebrauchsanweisung

Equipment Maintenance

After finishing work, cleaning the sprayer and blowing air through it, you should:
Unscrew hose connected to the handle, remove R40 filter, and clean it (preferably under running
•
water).
Unscrew the bottom nut R50 from the feeding valve - R020j, remove the valve piston with
•
a spring, clean it, lubricate with silicon lubricant, put it back into the valve and screw in the nut
tight.
Unscrew the yellow nozzle cap R115, then unscrew the black nozzle nut R64, take out the
•
nozzle core, wash it, lubricate the O-ring on the core and reassemble it again.
Unscrew the cap of the tank RP11, take out the funnel RP22, take out the diaphragm tank cap
•
R322 without removing it from the hose, then take out the o-ring and wash or exchange the
filter. When it's done, put the filter and the o-ring back into the cap R322. Then put the
diaphragm tank cap R322 inside the tank. When placed in a tank, make sure that the cap touches
the bottom of the tank.
Note!
All repairs, replacements or maintenance of the pump, battery or control panel
can be done only in the Marolex premises or by authorized services.
Repairing, replacing or maintenance of the elements mentioned above on their
own results in loss of warranty.
GB

General Comments

In the lance's handle there's a filter (R40) installed, designed to protect nozzles from clogging. All
Marolex lances are interchangeable (the same thread in all of them). It is possible to use additional
extensions (60 and 100 cm) produced by Marolex. With MAROLEX sprayers a wide range of
nozzles can be used: cone-shaped, deflecting, flatstream, with adjustable stream angle and with
different output. The construction of Marolex lances allows the use of nozzles produced also by
other manufacturers.
18