Charger Operation - nomad 18 VOLT Bedienungsanleitung

WARNING:
If any parts are damaged or missing,
do not operate this product until the
parts are replaced. Failure to heed this
warning could result in serious personal
injury.
WARNING:
Do not attempt to modify this product or
create accessories not recommended
for use with this product. Any such
alteration or modification is misuse and
could result in a hazardous condition
leading to possible serious personal
injury.
WARNING:
Cleaner assembly may include small
parts. Small parts can present a choking
hazard.
APPLICATIONS
You may use this product for the following
purposes:
n Charging compatible Nomad 18 volt
Li-ion
and Ni-Cd battery packs.
BATTERY PROTECTION FEATURES
Nomad 18 volt Li-ion battery pack is
designed with features that protect the
Lithium-ion cells and maximize battery
life.
If the tool stops during use, release the
trigger to reset and resume operation. If
the tool still does not work, the battery
needs to be recharged.
CHARGING THE BATTERY PACK
Use only Nomad 18 volt Li-ion and
Ni-Cd battery packs with this charger:
ASSEMBLY

CHARGER OPERATION

Battery packs for this tool are shipped
in a low charge condition to prevent
possible problems. Therefore, you
should charge them until the green LED
on the front of the charger stays on.
CHARGING A BATTERY PACK
If the charger does not charge
t h e b a t t e r y p a c k u n d e r n o r m a l
circumstances, return both the battery
pack and charger to your nearest
Authorized Service Center for electrical
check.
■ Charge the battery pack only with the
■ Make sure the power supply is normal
■ Make sure the latches on each side
17
PLEASE NOTE:
AUTOMATIC SHUT-OFF
When the trigger is released, the
dynamic pressure shuts the motor
off automatically. When the trigger is
pressed, the pressure drop automatically
activates the motor and pressure is
formed again with a slight delay.
To ensure correct automatic shutoff
operation, the time interval between
trigger release and engagement must
not be less than 5-10 seconds.
To ensure correct use of automatic
shutoff, do not leave the machine in
automatic shutoff condition for more
than 10 minutes.
charger provided.
household voltage, 220V-240V~50Hz,
AC only.
of the battery pack snap into place