Herunterladen Inhalt Inhalt Diese Seite drucken

Panasonic JS-970 Series Handbuch Seite 50

Pos workstation
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 56
Specifications
* 3
: RAID can be set up only by the JS-970WS type, which is equipped with a stand
unit. An optional Storage Bracket for Stand Unit (JS-970HDB010) and HDD Module
(JS-970HDD010) or SSD Module (JS-970SSD010) need to be attached to the stand
unit used.
In addition, you need to combine an HDD with another HDD, and an SSD with
another SSD.
* 4
: Intel
H81 Chipset-installed models are not RAID-ready.
®
* 5
: Attachment of the supplied Modular-D-SUB9 Conversion Cable (JS-970KM9010)
allows a D-SUB Cable to be connected.
* 6
: A VGA interface monitor becomes available through the use of an optional
DisplayPort-VGA Conversion Adapter (JS-970KDV010).
* 7
: A cash drawer of the 6 pin / 24 V modular type can be used. DIN connector / 12 V
type cash drawer becomes available through the use of an optional Modular-DIN
Conversion Cable (JS-970KMC010).
* 8
: Operation has been tested and confirmed using Panasonic SD Memory Card with a
capacity of up to 2 GB, Panasonic SDHC Memory Card with a capacity of up to 32
GB, and Panasonic SDXC Memory Card with a capacity of up to 64 GB.
Operation on other SD equipment is not guaranteed.
* 9
: The AC adapter for this equipment is rated at 100 V AC to 240 V AC at 50 Hz /
60 Hz.
Use only specified AC cord. For the AC cord for exclusive use, contact your
technical support office.
* 10 : The Customer Display Unit and the 2nd LCD Display Unit / 2nd VGA display cannot
be used at the same time.
* 11 : JS-970RD-010 should be used for the JS-970WS type.
JS-970RD-020 should be used for the JS-970WP type.
* 12 : The 2nd LCD Display is of two types: JS-970SD-010 (with camera & touch panel)
and JS-970SD-020 (without camera & touch panel).
The 2nd LCD Display can be used only with the JS-970WS type equipped with a
stand unit. An optional 2nd LCD Display Bracket (JS-970SDB010) is required to
install the 2nd LCD Display.
* 13 : The value obtained when standard POS software is normally operated. It may vary
depending on the software used. The power consumption of each model equipped
with an internal battery pack increases by 18 W when the internal battery pack is
put on charge.
* 14 : The mass of the high end model with 15 type Display installed. Option devices are
not included.
50

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis