Panasonic JS-970 Series Handbuch Seite 19

(JS-970WP series)
Procure fixing screws separately.
● The screws that secure this product are not supplied. Prepare them according to the
material and strength of the area where the product is to be installed.
Screw tightening
● The screws and bolts must be tightened with an appropriate tightening torque according
to the material and strength of the installation area.
● Do not use an impact driver. Use of an impact driver may damage the screws or cause
tightening excessively.
● When a screw is tightened, make the screw at a right angle to the surface. After
tightening the screws or bolts, perform visual check to ensure tightening is enough and
there is no backlash.
(JS-970WS series)
Display angle adjustment
● Take care not to place the fingers between the main block and the stand unit when the
angle of display is adjusted. Injury may occur. Adjust the display tilt- and swivel angles
with two hands placed on outside, bezel edges of the display unit.
● To adjust the display angle, slowly move the display.
● With the display placed in a horizontal position, putting an object on top of it, or pressing
it down firmly, can result in possible damage to the hinge part in the direction of swivel
rotation.
Be sure to remove this product if it is not in use.
19