Precautions For Use - Panasonic JS-970 Series Handbuch

Precautions for Use

Attention for capacitive touch screen
● Do not touch it by finger nail, because capacitive touch screen can not recognize it.
Touch it by finger tip.
● Do not touch it during startup. It initializes touch screen during startup. If it is touched
during startup, touch screen is not initialized correctly.
● Be careful to not accidentally touch around display edges or press on display bezel as it
can negatively affect display touch sensor accuracy.
● Touch screen calibration can be affected by atmospheric change. In case of calibration
shifted, perform a calibration adjustment.
● Adequacy of touch screen reaction-time or sensitivity may vary by operator. Display
sensitivity can be adjusted by executing a display sensitivity adjustment program. *
● Capacitive touch-screen panel uses radio frequency to detect finger tip touch. Terminals
are configured to use different frequencies to avoid conflict in the event of two or more
terminals operating within 1.5 m (approx. 5 inches) of each other. In the event of conflict
('ghost' or inexplicable touch-screen reaction(s)), shutdown and reboot the terminal to
reselect touch screen frequency.
*
Inquire to the supplier about the display sensitivity adjustment program.
1
Attention for resistive touch screen
● Do not touch with your finger nail or the tip of a pen. Otherwise the touch screen film can
be damaged or torn, causing a possible failure. Touch it by finger tip.
● Do not touch it during startup. It initializes touch screen during startup. If it is touched
during startup, touch screen is not initialized correctly.
HDD
● For replacement or removal / installation of the HDD, contact the company from which
you have purchased it. Do not allow any person other than servicemen to perform such
work, as it may possibly cause an HDD or equipment failure.
Use of speakers
● Do not emit a sound such as warning beeps at the maximum volume from the speakers
for a long time.
Carrying / moving terminals
● Do not lift or carry the equipment by holding onto the cable cover, display unit or second
display. Firmly tighten the finger screws on the back of the display, and securely hold the
equipment at the bottom with both hands when lifting or carrying it.
18
1