NGS Home N-Cut Sixinone Gebrauchsanweisung Seite 20

Replacings
REPLACING THE CUTTER UNIT
n order to replace a worn or damaged cutter unit, please contact
customer support of NGS Home (+34) 902 11 46 86.
REPLACING THE MICROSHAVER BLADE
If the metal is damaged, do not continue using it; replace it for
another original blade authorized by the NGS Home service.
• Extract the removable shaving header (fig 26).
• Separate the removable header shaver blade (fig 27).
• Place the new blade in the removable header (fig 28).
• After placing the blade in the header, push it into its position with
your finger (fig 29).
REPLACING THE MICROSHAVER CUTTER
If the microshaver is damaged replace it and the blade immediately
for original parts authorized by the NGS Home service.
• Extract the removable shaving header (fig 26). Remove the old
cutter of the microshaver by pulling from it (Fig. 30).
• Make sure you do not loose the spring of the movement unit.
• Insert a new microshaver cutter in the movement unit (fig. 31).
• When the microshaver cutter is in the correct position, push it
with your fingers to the end.
• Place the removable shaver header on the device.