Operation; Maintenance - McCulloch UNIVERSAL MTO003 Betriebsanweisung

WARNING:
release button is locked in the primary hole
and the knob is securely tightened before op-
erating the unit. All attachments are designed
to be used in the primary hole unless other-
wise stated in the applicable attachment in-
struction manual. Using the wrong hole could
lead to serious injury or damage to the unit.
Locking/Release
Button in Primary Hole
OPERATING POSITION
ALWAYS WEAR:
Hearing
Protection
Long Pants
Heavy Shoes
WARNING:
sure to high noise levels may cause permanent
hearing impairment. Wear approved hearing
protection when operating the blower.
WARNING:
connect spark plug wire before performing

maintenance.

CHECK FOR DAMAGED OR
WORN PARTS
Contact an authorized service center for
replacement of damaged or worn parts.
S Impeller housing - - discontinue use of
blower if impeller housing is damaged.
CHECK FOR LOOSE FASTENERS
AND PARTS
S Housing Screws
Make sure the locking/

OPERATION

Eye Protection
Long or continuous expo-
MAINTENANCE
Always stop unit and dis-
INSTALLING ATTACHMENT
HANGER
An attachment hanger is provided for storage
when attachment is not in use. To install hang-
er on attachment:
1. Remove the shaft cap from the attach-
ment (if present) and discard.
2. Press and hold the locking/release but-
ton.
3. Push hanger onto the attachment until
the locking/release button snaps into the
hole.
OPERATING INSTRUCTIONS FOR
BLOWER ATTACHMENT
Use the blower attachment for sweeping debris
or grass clippings from driveways, sidewalks,
patios, etc., for blowing grass clippings, straw, or
leaves into piles, or removing debris from cor-
ners, around joints, or between bricks.
S Control air flow by directing the blower dis-
charge opening down or to one side.
S Always work away from solid objects such as
walks, large stones, vehicles, and fences.
S Clean corners by starting in corners and mov-
ing outward. This will help prevent an accu-
mulation of debris which could fly into your
face.
S Be careful when working near plants. The
force of the air could damage tender plants.
INSPECT AND CLEAN UNIT
AND LABELS
S After each use, inspect complete unit for
loose or damaged parts. Clean the unit and
labels using a damp cloth with a mild deter-
gent.
S Wipe off unit with a clean dry cloth.