ASROCK 4Core1333-FullHD Schnellinstallationsanleitung Seite 12

Step 1. Open the socket:
Step 1-1. Disengaging the lever by depressing
Step 1-2. Rotate the load lever to fully open po-
Step 1-3. Rotate the load plate to fully open po-
Step 2. Insert the 775-LAND CPU:
Step 2-1. Hold the CPU by the edges where are
Step 2-2. Orient the CPU with IHS (Integrated
Pin1
orientation
key notch
775-LAND CPU
For proper inserting, please ensure to match the two orientation key
notches of the CPU with the two alignment keys of the socket.
Step 2-3. Carefully place the CPU into the socket
Step 2-4. Verify that the CPU is within the socket
Step 3. Remove PnP Cap (Pick and Place Cap):
Use your left hand index finger and thumb to
support the load plate edge, engage PnP cap
with right hand thumb and peel the cap from the
socket while pressing on center of PnP cap to
assist in removal.
1 2 1 2 1 2 1 2 1 2
down and out on the hook to clear
retention tab.
sition at approximately 135 degrees.
sition at approximately 100 degrees.
marked with black lines.
Heat Sink) up. Locate Pin1 and the two
orientation key notches.
orientation
key notch
by using a purely vertical motion.
and properly mated to the orient keys.
ASRock 4Core1333-FullHD Motherboard
Pin1
alignment key
alignment key
775-Pin Socket