Adjusting The Display Brightness; Checking The Operation Time; Making Connections; Making Communication Settings On The Connected Unit - Tascam RC-SS150 Bedienungsanleitung

Adjusting the display brightness

You can adjust the display brightness as necessary.
When the Menu Screen is open, use the PAGE [MENU] − and +
buttons to adjust the brightness of the display.
NOTE
The display brightness setting is retained even when the unit is
turned off.

Checking the operation time

When the menu screen is open, while pressing the L
, press the STOP button to open a pop-up
DISPLAY] button
message like the one shown below that shows the operation
(powered) time of the unit.
Press any button to close the pop-up message.

Making connections

Connect the RS-232C connector on the back of this unit to the
RS-232C connector on the SS-R250N/SS-CDR250N unit with the
included RS-232C connection cable.
CAUTION
Always turn the SS-R250N/SS-CDR250N unit power off before
connecting or disconnecting the cable. Connecting the cable
with the power on could damage the unit.
Making communication settings on
the connected unit
To use this unit, the following communication settings must be
made on the connected unit.
When connected to an SS-R250N/SS-CDR250N
8
1.
Press the MENU [JOG] button on the SS-R250N/SS-
CDR250N to open the Menu Screen.
2.
Select the RS-232C item on the REMOTE page to open the
RS-232C screen.
OAD [TIME
3.
Set the items on the RS-232C screen to the following values.
RC-232C screen
item
BAUD RATE
PARITY BIT
STOP BIT
DATA LENGTH
4.
After you complete setting all the items, press the HOME/
DISPLAY button on the SS-R250N/SS-CDR250N to return to
the Home Screen.
Option
57600 bps
NON
1
8
TASCAM RC-SS150
9