Names Of Parts; Top Panel; Rear Panel - Tascam RC-SS150 Bedienungsanleitung

Names of Parts

Top panel

1 1-12 (flash playback) buttons
Press these button when the Home Screen is open to start
playback of the tracks assigned to them.
If a track has been flash loaded, playback will start
immediately (flash playback).
If it has not been flash loaded, playback will start in the
ordinary manner.
When a Menu Screen is open, turn to select items and setting
values.
When the playlist selection screen is open, turn to select
playlists.
2 Color display
This 3.5-inch TFT color display has a 320×240 resolution. It
shows various types of information.
NOTE
The display is produced with extremely high-precision manufac-
turing technologies. At least 99.99% of the pixels operate as
specified. On rare occasions, a pixel might misfire or appear as a
red or black dot, but this is not a malfunction.
3 PAGE −/+ [MENU] buttons
Use these buttons when the Home Screen is open to change
the page.
Tracks are assigned to flash playback buttons on each page.
Changing the page also changes the assigned tracks.
For details about assigning tracks, see "6 − Editing the
playlist" in the SS-R250N/SS-CDR250N Owner's Manual.
Press the + button to open the next page. Press when the last
page is shown to open the first page.
Press the − button to open the next page. Press when the first
page is shown to open the last page.
When the Home Screen is open, press the − and + buttons at
the same time to open the Menu Screen.
When the Menu Screen is open, the brightness of the color
display can be changed.
When the playlist selection screen is open, use these buttons
to change the page if there are more than 12 playlists. Press
the − and + buttons at the same time to return to the Menu
Screen.
6
TASCAM RC-SS150
NOTE
This unit can be used to operate audio sources numbered 1–96 (8
pages with 12 each) within the set play area.
4 LOAD [TIME DISPLAY] button
Press and hold this button when the Home Screen is open to
flash load if the SS-R250N/SS-CDR250N unit is in a play mode
that enables flash loading.
Press this button when the Home Screen is open to switch
the time display between showing the elapsed time from the
track beginning and the remaining time to the track end.
Press this button when the playlist selection screen is open to
flash load the selected playlist.
When the Menu Screen is open, press this button to return to
the Home Screen.
5 STOP button
Press to stop playback.
6 PLAY button
Press when stopped or in playback standby to start playback.

Rear panel

7 RS-232C connector
Use the included RS-232C cable to connect this to an SS-R250N
or SS-CDR250N.
CAUTION
Always turn the SS-R250N/SS-CDR250N unit power off before
connecting or disconnecting the cable. Connecting the cable
with the power on could damage the unit.