Messages; General; Dimensional Drawings - Tascam RC-SS150 Bedienungsanleitung

Messages

The following is a list of the pop-up messages.
Refer to this list if one of these pop-up messages appears on the RC-SS150 and you want to check the meaning or determine a proper
response.
Message
Cannot Change Now
Currently Playing.
Cannot Change Now
Currently Recording.
Cannot use
Flash Load and Playback.
Playlist has no tracks.
Cannot use
Flash Load and Direct Play
in Random playback mode.
Communication is not available.
Cannot communicate
with Main Unit.
Flash Loading ...
Loading Playlist ...
Operation failed.

General

Power supply voltage
DC12V (supplied by SS-R250N/SS-CDR250N unit)
Power consumption
1.30W or less
Dimensions
176 x 59 x 215mm (width × height × depth)
Weight
1.1kg
Operating temperature range
5–35º C/41–95ºF
Connection (RS-232C serial port)
8
Connector:
Connection cable:
Transmission speed:
Data bits:
Parity:
Stop bit:
No flow control
Pin
Signal name
number
1 NC
2 TxD
3 RxD
4 NC
5 Ground
6 NC
7 NC
8 NC
9 Power +12V
10
TASCAM RC-SS150
Meaning and response
This item cannot be changed during playback.
This item cannot be changed during recording.
Since no tracks have been added to the playlist, flash-loading and playback are not possible.
Flash loading and direct playback cannot be used when in random playback mode.
This unit cannot communicate with the connected unit.
Check the communication settings on the connected unit.
Check the connection with the connected unit.
Flash-start data is being loaded.
A playlist is being loaded.
The operation could not be completed for some reason.
9-pin D-sub (female, inch-standard)
9-pin D-sub straight cable
(15 m or less)
57600 bps
8-bit
None
1

Dimensional drawings

176mm
• Illustrations in this manual might differ in part from actual
products.
• In order to improve the products, specifications and
appearance could be changed without prior notice.